Allied Telesis AT-S63 - Manual (Page 493)

AT-S63 Management Software Command Line User’s Guide
Section III: Snooping Protocols 493
The parameters in the MLD Snooping Configuration section are explained
“SET IPV6 MLDSNOOPING” on page 488.
The Host List section displays the following information:
 Multicast Group - The multicast address of the group.
 VLAN - The VID of the VLAN where the port is an untagged member.
 Port/TrunkID - The port on the switch where the host node is
connected. If the host node is connected to the switch through a trunk,
the trunk ID number, not the port number, is displayed.
 HostIP - The IP address of the host node connected to the port.
 Exp. Time - The number of seconds remaining before the host is timed
out if no further MLD reports are received from it.
The Router List section displays this information:
 VLAN - The VID of the VLAN in which the port is an untagged member.
 Port/Trunk ID - The port on the switch where the multicast router is
connected. If the switch learned the router on a port trunk, the trunk ID
number, not the port number, is displayed.
 Router IP - The IP address of the multicast router.
Example
The following command displays the current MLD parameter settings,
along with the host and router lists:
show mldsnooping
Equivalent Command
show ipv6 mldsnooping hostlist routerlist
For information, see “SHOW IPV6 MLDSNOOPING” on page 495.
AlliedWare Plus
Command
Syntax
show ip mld snooping
Mode
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus command is equivalent to the standard command.