Show snmpv3 targetparams, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 567
AT-S63 Management Software Command Line User’s Guide
Section IV: SNMPv3
567
SHOW SNMPV3 TARGETPARAMS
Syntax
show snmpv3 targetparams[=
targetparams
]
Parameter
targetparams
Specifies an SNMPv3 Target Parameters Table entry.
Description
This command displays SNMPv3 Target Parameters Table entries. You
can display one or all of the table entries.
Examples
The following command displays the entire SNMPv3 Target Parameters
Table:
show snmpv3 targetparams
The following command displays the SNMPv3 Target Parameters Table
entry called “snmpv3manager95”:
show snmpv3 targetparams=snmpv3manager95
AlliedWare Plus
Command
Syntax
show snmp-server targetparams
Mode
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus command displays the entire SNMPv3 Target
Parameters Table. Unlike the standard command it does not allow you to
specify an individual entry.
Example
awplus# show snmp-server targetparams
Command
Available
AlliedWare Plus