Enable snmp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 143
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Features
143
ENABLE SNMP
Syntax
enable snmp
Parameters
None.
Description
This command activates SNMP on the switch so that you can remotely
manage the unit with an SNMP application program from a management
station on your network. It also enables the switch to send SNMP traps to
trap receivers. The default setting for SNMP on the switch is disabled.
This command does not affect the status of authentication failure traps. To
enable the traps, refer to “ENABLE SNMP AUTHENTICATETRAP” on
page 144.
Example
The following command activates SNMP on the switch:
enable snmp
AlliedWare Plus
Command
Syntax
snmp-server enable trap
Mode
Configure mode
Description
This AlliedWare Plus command enables both SNMP and authentication
failure traps. The standard commands have a separate command for
enabling authentication failure traps.
Example
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server enable trap
Command
Available
AlliedWare Plus