Enable garp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 666
Chapter 35: GARP VLAN Registration Protocol Commands
666
Section VI: Virtual LANs
ENABLE GARP
Syntax
enable garp=gvrp [gip]
Parameters
garp
Specifies the GARP application to be activated.
GVRP is the only GARP application supported by the
AT-9400 Switch.
gip
Enables GARP Information Propagation (GIP).
Note
The online help for this command contains an STP option. This
option is not supported.
Description
This command enables GVRP on the switch. After activated, the switch
will learn dynamic GVRP VLANs and dynamic GVRP ports.
You can also use this command to enable GIP. GIP must be enabled for
GVRP to operate properly.
Examples
The following command enables GVRP on the switch:
enable garp=gvrp
The following command enables GIP only:
enable garp=gvrp gip
AlliedWare Plus
Command
Syntax
To enable GVRP:
gvrp enable
To enable GIP:
gvrp applicant state active
or
gvrp dynamic-vlan-creation enable
Command
Available
AlliedWare Plus