Allied Telesis AT-S63 - Manual (Page 395)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 395
parameter. This is the default.
tos Specifies a replacement value to write into the Type
of Service (ToS) field of IPv4 packets. The range is
0 to 7.
A new ToS value can be set at all three levels: flow
group, traffic class, and policy. A ToS value
specified in a flow group overrides a ToS value
specified at the traffic class or policy level.
movetostopriority Replaces the value in the 802.1p priority field with
the value in the ToS priority field in IPv4 packets.
Options are:
yes, on, true Replaces the value in the 802.1p
priority field with the value in the ToS
priority field in IPv4 packets.
no, off, false Does not replace the preexisting
802.1p priority level This is the
default.
moveprioritytotos Replaces the value in the ToS priority field with the
802.1p priority field on IPv4 packets. Options are:
yes, on, true Replaces the value in the ToS
priority field with the 802.1p priority
field in IPv4 packets.
no, off, false Does not replace the ToS priority
field. This is the default.
flowgrouplist Specifies the flow groups to be assigned to the
traffic class. The specified flow groups must already
exist. Separate multiple IDs with commas (e.g.,
4,11,13).
Description
This command is used to create new traffic classes.
Note
For examples of the command sequences for entire QoS policies,
refer to “CREATE QOS POLICY” on page 384.