Allied Telesis AT-S63 - Manual (Page 515)

AT-S63 Management Software Command Line User’s Guide
Section IV: SNMPv3 515
defaults to none.
notifyview Specifies a Notify View Name that allows the users
assigned to this Group Name to send traps
permitted in the specified View. This is an optional
parameter. If you do not assign a value to this
parameter, then the notifyview parameter defaults to
none.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table
entry to the configuration file on the
switch. This is the default.
nonvolatile Allows you to save the table entry to
the configuration file on the switch.
Description
This command creates SNMPv3 Access Table entries.
Examples
The following command creates a security group called “testengineering”
with a security model of SNMPv3 and a security level of privacy. The
security group has a read view named “internet,” a write view named
private, and a notify view named “internet.” The storage type is nonvolatile
storage.
create snmpv3 access=testengineering securitymodel=v3
securitylevel=privacy readview=internet writeview=private
notifyview=internet storage=nonvolatile
The following command creates a security group called “swengineering”
with a security model of SNMPv3 and a security level of authentication. In
addition, the security group has a read view named “internet,” a write view
named experimental, and a notify view named “mgmt” (management). The
storage type group is nonvolatile storage.
create snmpv3 access=swengineering securitymodel=v3
securitylevel=authentication readview=internet
writeview=experimental notifyview=mgmt storage=nonvolatile
The following command creates a security group called “hwengineering”
with a security model of SNMPv3 and a security level of noauthentication.
In addition, the security group has a read view named “internet.”
create snmpv3 access=hwengineering securitymodel=v3
securitylevel=authentication readview=internet