Destroy snmpv3 notify, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 536
Chapter 30: SNMPv3 Commands
536
Section IV: SNMPv3
DESTROY SNMPv3 NOTIFY
Syntax
destroy snmpv3 notify=
notify
Parameter
notify
Specifies an SNMPv3 Notify Table entry.
Description
This command deletes SNMPv3 Notify Table entries. After you delete an
SNMPv3 Notify Table entry, you cannot recover it.
Examples
The following command deletes an SNMPv3 Notify Table entry called
“systemtestnotifytrap.”
destroy snmpv3 notify=systemtestnotifytrap
The following command deletes an SNMPv3 Notify Table entry called
“engineeringinform1.”
destroy snmpv3 notify=engineeringinform1
AlliedWare Plus
Command
Syntax
no snmp-server notify
notify
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
This example deletes an SNMPv3 Notify Table entry called
“testwesttrap1”:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server notify testwesttrap1
Command
Available
AlliedWare Plus