Allied Telesis AT-S63 - Manual (Page 40)

Chapter 1: Overview
40 Section I: Basic Operations
Moving Down the
Hierarchy
To move down through the hierarchy, you have to move through the
modes in sequence. Skipping modes is not allowed.
There is a different command for each mode. To move from the User Exec
mode to the Privileged Exec mode, for instance, use the ENABLE
command. Some of the commands require a value, like the INTERFACE
PORT command which must have one or more port numbers and which is
used to enter the Port Interface mode.
AWPLUS Command
You use this command at the standard command line prompt to enter the
AlliedWare Plus command line interface and the User Exec mode. If you
log on as an operator, this is as far in the hierarchy as you can go. To go
further, you have to log on as a manager.
The format of the command is:
awplus
Figure 7. Using the AWPLUS Command to Start the AlliedWare Plus
Command Line Interface
ENABLE Command
You use this command to move from the User Exec mode to the
Privileged Exec mode. The format of the command is:
enable
Figure 8. Moving from the User Exec Mode to the Privileged Exec Mode
with the ENABLE Command
Allied Telesis (TM) AT-9448Ts/XP AT-S63
Switch 12a
# awplus
AlliedWare Plus (TM) AT-9448Ts/XP AT-S63
awplus>
AlliedWare Plus (TM) AT-9448Ts/XP AT-S63
awplus> enable
awplus#