Allied Telesis AT-S63 - Manual (Page 752)

Chapter 38: Internet Protocol Version 4 Packet Routing Commands
752 Section VII: Internet Protocol Routing
SHOW IP ROUTE
Syntax
show ip route [general] [fdb] [full]
Parameters
general Displays general routing information, such as the total
number of routes in the cache and the cache size.
fdb Displays the status of the static and dynamic routes.
full Displays both the routes and the general routing
information.
Description
Entering this command without the optional parameters displays all the
static and RIP routes on the IPv4 interfaces. An example of the
information is shown in Figure 85.
Figure 85. SHOW IP ROUTE Command
The columns are described here:
 Destination - Destination IP address of the network or subnet. The
default route is 0.0.0.0.
 Mask - Subnet mask of the destination IP address.
 Protocol - Source of the route. Possible options are:
– Interface - Route was learned by a routing interface.
– Static - Route was entered manually as a static route.
– RIP - Route was learned by RIP.
Command
Available
AlliedWare Plus
IP Routes
---------------------------------------------------------
Destination
Mask NextHop Interface
Protocol RipMetric Preference
---------------------------------------------------------
0.0.0.0
0.0.0.0 202.24.124.2 VLAN2-0
Static 1 60
149.102.34.0 255.255.255.0 149.211.54.6 VLAN14-0
Interface 1 1
149.102.37.0 255.255.255.0 149.211.54.6 VLAN14-0
Interface 1 1