Delete snmpv3 user, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 531
AT-S63 Management Software Command Line User’s Guide
Section IV: SNMPv3
531
DELETE SNMPV3 USER
Syntax
delete snmpv3 user=
user
Parameters
user
Specifies the name of an SNMPv3 user to delete
from the switch.
Description
This command deletes SNMPv3 User Table entries. After you delete an
SNMPv3 user from the switch, you cannot recover it.
Examples
The following command deletes the user named “wilson890.”
delete snmpv3 user=wilson890
The following command deletes the user named “75murthy75.”
delete snmpv3 user=75murthy75
AlliedWare Plus
Command
Syntax
no snmp-server user
user
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
This example deletes an SNMPv3 User Table entry called “rs12eng”:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server user rs12eng
Command
Available
AlliedWare Plus