Allied Telesis AT-S63 - Manual (Page 241)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 241
SHOW SWITCH MIRROR
Syntax
show switch mirror
Parameters
None.
Description
This command displays the source and destination ports of the port mirror
on the switch. An example is shown in Figure 45.
Figure 45. SHOW SWITCH MIRROR Command
The command provides the following information about the port mirror:
 Mirroring State - The port mirroring status, Enabled or Disabled. If port
mirroring is disabled on the switch, only this line is displayed by the
command.
 Mirror-To (Destination) Port - The port functioning as the destination
port.
 Ingress (Rx) Mirror (Source) Port - The port(s) whose ingress
(received) traffic is mirrored.
 Egress (Tx) Mirror (Source) Port - The port(s) whose egress
(transmitted) traffic is mirrored.
Example
The following command displays the status and the ports of the port
mirror:
show switch mirror
Command
Available
AlliedWare Plus
Port Mirroring:
Mirroring State ..................... Enabled
Mirror-To (Destination) Port ........ 22
Ingress (Rx) Mirror (Source) Ports .. 1,3
Egress (Tx) Mirror (Source) Ports ... 1,3,11-13