Allied Telesis AT-S63 User Manual
Page 164
Chapter 8: Port Parameter Commands
164
Section I: Basic Operations
yes, on, true, enabled
Activates backpressure
on the port. These
options are equivalent.
no, off, false, disabled Deactivates
backpressure on the
port. This is the default.
These options are
equivalent.
bplimit
Specifies the number of cells for backpressure.
A cell represents 128 bytes. The range is 1 to
7935 cells. The default value is 7935 cells.
holbplimit
Specifies the threshold at which the switch
signals a head of line blocking event on a port.
The threshold is specified in cells. A cell is 128
bytes. The range is 1 to 61,440 cells; the default
is 7,168.
renegotiation
Prompts the port to renegotiate its speed and
duplex mode with the end node. This parameter
only works when the port is using Auto-
Negotiation. The only option is:
auto
Renegotiates speed and duplex
mode with the end node.
softreset
Resets the port. This parameter does not
change any of a port’s operating parameters.
Description
This command configures the operating parameters of a port. You can set
more than one parameter at a time.
Examples
The following command disables ports 1 to 6:
set switch port=1-6 status=disabled
The following command configures port 8 to operate at 10 Mbps, half
duplex:
set switch port=8 speed=10mhalf
The following command sets the speed on ports 2 to 6 to 100 Mbps, the
duplex mode to full duplex, the wiring configuration to MDI-X, and flow
control to enabled:
set switch port=2-6 speed=100mfull mdimode=mdix
flowcontrol=enabled