Allied Telesis AT-S63 - Manual (Page 77)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 77
Syntax 4 Description
You use this command to configure a stand-alone switch or a stack with a
different configuration file. You might do this to test the switch or stack with
a different configuration.
When you enter the command, the switch or stack automatically resets
itself and afterwards configures its parameters according to the settings in
the specified configuration file. However, the assignment of the active boot
configuration file does not change. Resetting or power cycling the switch
again causes the unit to revert to its previous configuration. To change the
assignment of the active boot configuration file, refer to “SET CONFIG” on
page 266.
Your local or remote management session with the switch ends when you
reset the switch. You must reestablish the session to continue managing
the switch.
Syntax 1 Example
This command resets a stack:
restart switch
Syntax 2 Examples
This command resets a member switch with a stack ID 3 in a stack:
restart switch module=3
This command resets the member switches with the stack IDs 4 and 5:
restart switch module=4,5
Syntax 3 Example
This command restores the parameter settings to their default values on a
stand-alone switch or a stack:
restart switch config=none
Syntax 4 Examples
This command uses a configuration file with the name “switch12a.cfg” to
configure the parameter settings on a stand-alone switch:
restart switch config=switch12a.cfg
This command uses a configuration file with the name “stack_bld5.cfg” to
configure the parameter settings on a stack:
restart switch config=stack_bld.cfg