Add vrrp ipaddress, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 766
Chapter 40: Virtual Router Redundancy Protocol (VRRP) Commands
766
Section VII: Internet Protocol Routing
ADD VRRP IPADDRESS
Syntax
add vrrp=
vrid
ipaddress=
ipaddress
Parameters
vrrp
Specifies the ID of the virtual router, a number
between 1 and 255.
ipaddress
Specifies a secondary IP address to be backed up by
the specified virtual router. The IP address must be
compatible with the IP address and subnet mask
associated with the Ethernet interface over which the
virtual router is operating.
Description
This command adds a secondary IP address to the group of IP addresses
that are backed up by the specified virtual router. The new IP address
must be added to all the switches participating in the virtual router. The
maximum number of secondary addresses is 16.
Example
This example adds the IP address 205.42.19.162 to the group of IP
addresses that are backed up by the virtual router whose VRID is 34:
add vrrp=34 ipaddress=205.42.19.162
AlliedWare Plus
Command
Syntax
router vrrp
vrid
interface
ipaddress
Modes
For the ROUTER VRRP command:
Configure mode
For the INTERFACE command:
VRRP mode
Command
Available
AlliedWare Plus