Enable bpduguard, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 593
AT-S63 Management Software Command Line User’s Guide
Section V: Spanning Tree Protocols
593
ENABLE BPDUGUARD
Syntax
enable bpduguard
Parameters
None.
Description
This command is used to enable the BPDU guard feature, which monitors
edge ports and disables them if they receive BPDU packets. To view the
current status of this feature, use “SHOW BPDUGUARD” on page 605.
Note
An edge port that is disabled by the BPDU guard feature remains in
that state until you enable it with the management software. If a port
is still receiving BPDUs, you will need to disconnect the network
cable to prevent the feature from disabling it again.
Example
enable bpduguard
AlliedWare Plus
Command
Syntax
spanning-tree bpdu-guard
Mode
Configure mode
Description
This AlliedWare Plus command is equivalent to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree bpdu-guard
Command
Available
AlliedWare Plus