Allied Telesis AT-S63 - Manual (Page 162)

Chapter 8: Port Parameter Commands
162 Section I: Basic Operations
SET SWITCH PORT
Syntax
set switch port= port [description=” description ”]
[status=enabled|disabled]
[speed=autonegotiate|10mhalf|10mfull|100mhalf|100mfull|
1000mfull]
[mdimode=mdi|mdix|auto]
[flowcontrol=disable|enable|auto]
[fctrllimit=
value ]
[backpressure=yes|no|on|off|true|false|enabled|
disabled]
[bplimit=
value ]
[holbplimit= value ]
[renegotiation=auto]
[softreset]
Parameters
port Specifies the port to be configured. You can
configure more than one port at a time, but the
ports must be of the same medium type. For
example, you cannot configure twisted pair and
fiber optic ports with the same command.
description A description for the port, from 1 to 15
alphanumeric characters. Spaces are allowed,
but not special characters. A description that
contains spaces must be enclosed in double
quotes. Otherwise, the quotes are optional. You
cannot specify a description when configuring
more that one port.
status Specifies the operating status of the port. The
options are:
enabled The port forwards network traffic.
This is the default setting.
disabled The port does not forward network
traffic.
speed Sets the speed and duplex mode of the port.
The options are:
autonegotiate The port uses Auto-Negotiation
for both speed and duplex mode.
This is the default setting.
10mhalf 10 Mbps and half-duplex mode.
Command
Available
AlliedWare Plus