Allied Telesis AT-S63 - Manual (Page 664)

Chapter 35: GARP VLAN Registration Protocol Commands
664 Section VI: Virtual LANs
DISABLE GARP
Syntax
disable garp=gvrp [gip]
Parameters
garp Specifies the GARP application to be disabled. GVRP
is the only GARP application supported by the
AT-9400 Switch.
gip Disables GARP Information Propagation (GIP).
Note
The online help for this command contains an STP option. The
option is not supported.
Description
This command disables GVRP on the switch. When GVRP is disabled, the
switch cannot learn dynamic GVRP VLANs or dynamic GVRP ports.
You can also use this command to disable GIP.
Note
Do not disable GIP if the switch is running GVRP. GIP is required for
proper GVRP operation.
Examples
The following command disables GVRP on the switch:
disable garp=gvrp
The following command disables GIP only:
disable garp=gvrp gip
AlliedWare Plus
Command
Syntax
To disable GVRP:
no gvrp enable
To disable GIP:
gvrp applicant state normal
Command
Available
AlliedWare Plus