Allied Telesis AT-S63 - Manual (Page 690)

Chapter 36: Protected Ports VLAN Commands
690 Section VI: Virtual LANs
SET VLAN
Syntax
set vlan= name | vid port= ports frame=tagged|untagged
Parameters
vlan Specifies the name or VID of the VLAN to be
modified.
ports Specifies the port whose VLAN type is to be changed.
You can specify more than one port at a time. For
instructions on how to enter port numbers, refer to
“Port Numbers in Commands” on page 48.
frame Identifies the new VLAN type for the port. The type
can be tagged or untagged.
Description
This command changes a port’s VLAN type. You can use this command to
change a tagged port to untagged and vice versa.
Before using this command, note the following:
 Changing a port in a port-based, tagged, or protected ports VLAN from
untagged to tagged adds the port to the Default_VLAN as untagged.
 Changing a port in the Default_VLAN from untagged to tagged results
in the port being an untagged member of no VLAN.
 Changing a port from tagged to untagged removes the port from its
current untagged port assignment.
Examples
The following command changes port 4 in the Sales VLAN from tagged to
untagged:
set vlan=Sales port=4 frame=untagged