Allied Telesis AT-S63 - Manual (Page 228)

Chapter 12: LACP Port Trunking Commands
228 Section I: Basic Operations
ENABLE LACP
Syntax
enable lacp
Parameters
None.
Description
This command activates LACP on the switch. The default is disabled.
Example
The following command activates LACP:
enable lacp
Equivalent Command
set lacp state=enable
For information, see “SET LACP STATE” on page 232.
AlliedWare Plus
Command
The AlliedWare Plus command interface does not have a separate
command to enable LACP. LACP is automatically enabled when you use
the CHANNEL-GROUP command and create the first aggregator on the
switch. For instructions, refer to the AlliedWare Plus command in “ADD
LACP PORT” on page 220.
Command
Available
AlliedWare Plus