Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 218)

<4. GC-HMI (touch panel)>
4-31
IM 11B08A01-01E
Figure 4.37
TIP
• The selections Str. Sequence, Specify str., Cal (Val), Start cal (val), and Finish cal (val) are enabled for user
level B or higher.
• The selections Cancel spec., Cal (val) method, and Start/stop auto cal are enabled for user level C or higher.
• If Cal (Val) method is set to Manual or Semi-auto for all calibration/validation numbers, the Start/stop auto cal
parameter cannot be set.
(2) Changing GCM settings
a. Peak Setting
Set parameters related to peak recognition.
TIP
• This operation is available if the user level is set to C or higher.
• The stream number, SYS number, and peak number assigned to the active GCM are selectable here.
2nd Edition : May 11, 2012-00
4