Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 336)

<5. EtherLCD>
5-85
IM 11B08A01-01E
* Press F5 (Slot#), and Slot No. is displayed in the second line below. Use the numeric
keypad to select slot number and press Set/Ent to set the slot number. When the selected
slot is not DI, the message “Cannot select” is displayed in the second line below.
* Press F6 (DI#) and D/I number is displayed in the second line below. Use the numeric
keypad to select contact number and press Set/Ent to set the contact number. When the
selected contact number exceeds the limits, “Over limit” is displayed in the second line
below.
* When stream sequence is set in the Process assign, items to select stream sequence are
added.
* When stream is set in the Process assign, items to select a Stream number and the Number
of times and a GCN number display are added. The displayed GCN number cannot be set.
* When Over limit numerical values are selected for the Stream number and the Number of
times, “Over limit” is displayed in the second line below and the numerical values that were
set are not refl ected.
* When Range select is set in the Process assign, items to select a range assigned stream,
a range assigned peak and a range number for Range select and a GCN number are
additionally displayed. The displayed GCN number cannot be set.
* When Over limit numerical values are selected for a range assigned stream, a range
assigned peak and a range number, “Over limit” is displayed in the second line below and
the numerical values that were set are not refl ected.
* When Cal (Val) is set in the Process assign, selection items for Cal (Val) and a GCM number
are added.
* When Over limit numerical values are selected for a GCM number, “Over limit” is displayed
in the second line below and the numerical values that were set are not refl ected.
* When Operation mode is set in the Process assign, selection items for operation mode and
a GCM number are added.
* When Over limit numerical values are selected for a GCM number, “Over limit” is displayed
in the second line below and the numerical values that were set are not refl ected.
* When Alarm process is set in the Process assign, selection items for an alarm level and a
message are added.
* When the set numerical values are Over limit of the alarm level or a set message has more
than 22 characters, “Over limit” is displayed in the second line below and the numerical
values that were set are not refl ected.
2nd Edition : May 11, 2012-00
5