Yokogawa GC8000 Process Gas Chromatograph User Manual

Page 260

Advertising
background image

<5. EtherLCD>

5-9

IM 11B08A01-01E

F6 (Slot #):

Sets a slot number.

TIP

• The Status is refreshed automatically at a fi xed interval (1 second).
• On the initial screen, the smallest slot number among those of the D/O cards inserted is displayed.
• For the slot number setting, only slot numbers of D/O cards can be accepted.
• Up to CH3 are displayed for DI/O cards.
• One GCM stream identifying signal can be applied to multiple D/O cards.
• In the case where the Stream identifi cation has been set on the GCM Setup screen, the D/O is used for that

purpose.

Example: Stream

identifi cation setup for the GCM1 (where the fi rst number of the stream

identifi cation D/O is 1)

Slot

1

2

Stream

identifi cation

DO1

DO2

DO3

DO4

DO5

DO1

Up to 3 streams Stream

identifying fl ag

Stream

identifi cation

Stream

identifi cation

Normal output Normal output Normal output

Up to 7 streams Stream

identifying fl ag

Stream

identifi cation

Stream

identifi cation

Stream

identifi cation

Normal output Normal output

Up to 15 streams Stream

identifying fl ag

Stream

identifi cation

Stream

identifi cation

Stream

identifi cation

Stream

identifi cation

Normal output

Up to 31 streams Stream

identifying fl ag

Stream

identifi cation

Stream

identifi cation

Stream

identifi cation

Stream

identifi cation

Stream

identifi cation

Display Item

Name

Set Lower Limit Upper Limit

Unit

Remarks

Slot #

Slot number

1

5

Absolute slot number

DO #

D/O contact number

1

5

Number Relative contact number

Output item

No assignment

Stream sequence

Stream

Operation mode

Alarm

Timing

Cal/Val

Str valve select

* See Note.

Status

Off, On

Note:

1: The selected GCM number and stream sequence number are displayed.

2: The selected stream number is displayed

3: The selected GCM number and operation mode are displayed.

4: The selected GCM number and alarm level/concentration alarm are displayed.

5: The selected SYS number, SYS method and sequence order selection are displayed.

6: The selected GCM number and calibration/validation number are displayed.

2nd Edition : May 11, 2012-00

5

Advertising