Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 321)

<5. EtherLCD>
5-70
IM 11B08A01-01E
Table 5.4 Peak synchronization and peak copy items
Name Peak Synchronization Peak Copy
Absolute peak number 1
Peak name
○ ×
Stream number Ч Ч
Relative peak number Ч Ч
Peak execution ○ × *1
Always set copy target to Not executed.
Detector number or SYS number ○ ○
Process assign ○ ○
DCS output fl ag ○ ×
Ref Peak 1
Stream number
▲ ○
Peak number ▲ ○
Ref Peak 2
Stream number
▲ ○
Peak number ▲ ○
Measuring range ▲ ○
Unit ▲ ○
Normalization ○ ○
Factor 1
<1000-fold data>
Factor K, Factor a, Factor f
<10000-fold data> Compress fact.(air)
<100-fold data> Temp.(degC)
▲ ○
Factor 2
<1000-fold data>
Factor A, Factor b, RVP coef A, 0%
value, Area %, Std B.P
▲ ○
Factor 3
<1000-fold data>
Factor B, RVP coef B, 100% value
▲ ○
Factor 4
<1000-fold data> Std conc
<100000-fold data>
Set up Conc.
▲ ○
Range number ▲ ×
Gate cut method ○ ○
Auto tracking req ○ ○
Peak polarity ○ ○
Detected slope ○ ○
Detection level ○ ○
A/H req ○ ○
Integ method ○ ○
Cal method req ○ ×
Chrom gain req (Auto gain value) ○ ○
Peak std time ○ ○
Gate ON Time ○ ○
Gate OFF Time ○ ○
Linear Calc 1 factor ▲ ○
Linear Calc 2 factor
<10000-fold data> Section set stop
▲ ○
Linear Calc 3 factor ▲ ○
Linear Calc 4 factor ▲ ○
Linear Calc 5 factor
<10000-fold data>
Calib factor, Response factor
▲ ○
Std area ▲ ○
Min peak width ○ ×
Min peak height ○ ×
Min peak area ○ ×
Modbus address Ч Ч
Tracking Factor a Ч Ч
Tracking Factor b Ч Ч
2nd Edition : May 11, 2012-00