Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 290)

<5. EtherLCD>
5-39
IM 11B08A01-01E
Display Item Name Set Lower Limit Upper Limit Unit Remarks
User level B ○ Numeric: 4 characters
User level C ○ Numeric: 4 characters
User level C+ ○ Numeric: 4 characters
5.4 Table screen
To navigate to the Table Menu screen, press the menu key .
1 1 / 1 1 / 2 2
1 5 : 1 5 : 4 5 Table Menu (1/3) 1 1 / 1 1 / 2 2
1 5 : 1 5 : 4 5 Table Menu (2/3)
> - System Settings
> - Cal/Val Setup
- Operating Parameters - Multirange Setup
- Temperature Setup - Alarm Setup
- Detector Setup - Peak Assigments
- Method Setup - Communications Setup
- Stream Setup - D/O Setup
- Stream Sequence - D/I Setup
- Peak Setup-General - A/O Setup
- Peak Setup-Specifi c - A/I Setup
F1 F2 F3 F4 F5 F6 F1 F2 F3 F4 F5 F6
1 1 / 1 1 / 2 2
1 5 : 1 5 : 4 5 Table Menu (3/3)
> - Network Setup
- GCCU Setup
- Remote A/O Setup
- GCM Setup
- Method Setup
- SYS Setup
- User Programming
- Units Setup (User Defi ned)
- MODBUS CLIENT Setup
F1 F2 F3 F4 F5 F6
Figure 5.51 Table menu screen
• The menu items D/O Setup, D/I Setup, A/O Setup and A/I Setup are display-only when the
associated cards are not installed. Selecting any of them displays the error message.
• The menu item User Programming is display-only when it is not installed. Selecting it
displays the error message.
• The menu item SimDis Setup is visible when the Distillation is set on for at least one GCM
on the GCM Setup (2/2) screen.
• If the Analog output num is 0 on the GCCU Setup screen, the Remote A/O Setup cannot be
selected.
2nd Edition : May 11, 2012-00
5