RISCO Group LightSYS 2 - Manual (Page 107)

Installer Programming
Page 107
 
ZZ
Abort Alarm
This parameter defines whether a zone alarm report to the monitoring
station will be immediate or delayed:

ENABLE : A report to the MS will be delayed according to the Abort
Time Delay parameter 5) Communication > 2 MS > 6 MS Times > 2
Abort Alarm,
page 161).

DISABLE: A report to the MS will be sent immediately
Quick Keys Parameter Default Range
  
Bus Zones Configuration
The Bus Zone Parameters menu contains parameters that enable you to
program the special parameters of a bus zone. The options are
determined according to the bus detector type:

Lunar Grade 3: A dual technology ceiling detector with a
mounting height of up to 8.6m (28ft) that incorporates Anti‐
Cloak
TM Technology (ACT).

WatchOUT DT: A dual technology outdoor detector with signal
processing based on two Passive Infrared (PIR) channels and two
Microwave (MW) channels.

WatchOUT PIR: An outdoor detector with signal processing based
on two Passive Infrared (PIR) correlated channels

WatchIN DT Grade 3: A dual technology Grade 3 industrial
detector with signal processing based on two Passive Infrared (PIR)
channels and two Microwave (MW) channels.

iWISE QUAD Grade 2: A motion detector incorporating Quad PIR
technology

iWISE QUAD Grade 3: A motion detector incorporating Anti‐Mask
and Quad PIR technologies.