RISCO Group LightSYS 2 - Manual (Page 82)

Installer Programming
Page 82
Quick Keys Parameter Default Range
 
Error Speaker Time Out No Yes/No
This option determines the duration of the alarm that is generated via the
internal sounders (speakers) when the exit door is programmed as “Final
Exit”, and it is not closed once the exit time expires (an “EXIT ERROR”).
YES: The “EXIT ERROR” alarm in the internal speaker matches the alarm
bell timeout setting.
NO: The “EXIT ERROR” alarm in the internal speaker sounds
continuously until user reset.
 
Tamper Report No Yes/No
This option determines if a tamper signal will be reported to the MS
while the system is disarmed.
YES: A tamper signal will always be reported.
NO: A tamper signal will not be reported to the MS during the unset
period.
Note:
A tamper restore report to the MS is always reported, regardless of the
“TAMPER REP” definition
 
AC Trouble Arm Yes Yes/No
YES: The system can be armed with an AC trouble detected in the main
panel, power supply module or the bus sounder.
NO: The system cannot be armed with an AC trouble.
 
Strobe Arm No Yes/No
This option allows the strobe (internal or external activated by a utility
output ‐ Utility output >Follow Partition > Strobe Trigger) to confirm the
final arming of the system.
YES: A ten second strobe indication will occur after the system is armed.
NO: There will be no strobe indication when the system is armed.
 
Final Night Yes Yes/No
This option determines the behavior of a final exit zone when the system
is armed at Stay.
YES: There is no need to open and close the door if the door is closed, in
order to arm the system in Stay. The zone behaves like a regular
“EXIT(OP)” zone type.
NO: There will be no change in the operation of a final exit zone in Stay
arming.