RISCO Group LightSYS 2 - Manual (Page 176)

Installer Programming
Page 176
6 Audio
This menu is used to define voice message parameters.
Note
This menu will be displayed only if a voice module had been assigned to the system
The Audio Messages menu is divided into the following sub menus:

Messages, below

Local Announcements, page 178

Messages
Quick Keys Parameter Default Range

Messages
Use this menu to customize the spoken messages of Zones, Partitions,
Outputs , Macroʹs and Opening Message that the Voice module
announces when you access the system from a remote telephone or you
hear on the premises.
There are 2 ways to customize a voice message:
1. User recorded: The

Common Message and the

Library Messages are
user recorded messages. The recording can be done either from the
microphone located on the voice module expander or from a
microphone located on the Listen/Talk unit.
Note:
The definition of which microphone to use is determined by dip
switch 4 located on the voice module board.
2. Assign messages: The Zone / Partition/ Output and Macro messages
can be assigned with pre recorded messages. Each message can be
comprised of up to 4 words. Each word has been pre‐recorded and
assigned a number. When comprising a message the installer will
enter the number of each word into the message sequence. The
system recognizes the numbers and sounds the words assigned to
those numbers. For example: For the system to sound “Top Floor
Guest Bedroom”, you should enter the following sequence: 119 050
061 019. The table in Appendix D Library Voice Messages displays the
directory of the pre‐recorded programming descriptors, each is
identified by a 3 digit number.