RISCO Group LightSYS 2 - Manual (Page 235)

Installer Event Log Messages
Page 235
Event Message Description
MS=y restore Communication fail trouble restore to MS phone no. Y
MW restore z=xx
Trouble restore in the MW channel of BUZ zone XX
MW trouble z=xx
Trouble in the MW channel of BUZ zone XX
Next arm:p=y
Partition Y armed in Next Arm mode
Next dis:p=y
Partition Y disarmed in Next Disarm mode
No aux ps=y
Failure in the Aux power on power supply ID=X
No aux ze=y
Failure in the S. Aux power on zone expander Y
No bell ps=y
Bell trouble in power supply ID=Y
No Com IPC Communication failure between the LightSYS2 and IP card
No com kp=y
Communication failure between the LightSYS2 and keypad
ID=Y
No com kr=y
Communication failure between the LightSYS2 and Key Reader
ID=Y
No com voice
Communication failure between the LightSYS2 and the
Advanced Voice module
No com WME=y
Communication failure between the LightSYS2 and wireless
module expander ID=Y
No comm BZE=y
Communication failure between the LightSYS2 and bus zone
expander ID=Y
No comm PS=y
Communication failure between the LightSYS2 and power
supply Y
No comm Siren=y Communication failure between the LightSYS2 and siren Y
No comm uo=y
Bus communication failure with UO expander ID=Y
No comm z=xx
Bus communication failure with Bus zone XX
No comm ze=y
Bus communication failure with zone expander ID=Y
No comm. GSM No communication between the GSM/GPRS Module and the
LightSYS
No comm. LRT
No communication between the long range transmitter and the
LightSYS
No fault z=xx
Trouble restore in zone XX (TEOL zone or Bus zone input TEOL)
No jam wme=y
Jamming restore on wireless module expander ID=Y
No mask z=xx Anti mask trouble restore from zone XX
Nxt hom:p=y Partition Y is armed in Next Stay mode