RISCO Group LightSYS 2 - Manual (Page 86)

Installer Programming
Page 86
Quick Keys Parameter Default Range
 
20 Minutes Signal No Yes/No
YES: Prior to arming the system, the system will check for zones that did
not send a signal for more than 20 minutes. These zones will be regarded
as not ready. A partition assigned with a not ready zone cannot be
armed.
NO: Prior to arming, the system will not check whether a zone did not
send a signal for more than 20 minutes.
 
Attenuation No Yes/No
YES: The LightSYS2 device will be attenuated by six dB during the
communication test.
NO: The LightSYS2 device works in normal operation mode.
System: Controls: PD6662:2010
Quick Keys Parameter Default Range

PD6662:2010
This section refers to controls that apply to DD243 approvals.
 
Bypass Exit/Entry Yes Yes/No
YES: It is possible for the user to bypass an Exit/Entry zone.
NO: An Exit/Entry zone cannot be bypassed.
 
Entry Disable No Yes/No
YES: The alarm confirmation process will be disabled when the entry
time starts.
NO: The alarm confirmation process will start when the entry time
starts.
 
Route Disable No Yes/No
YES: The panel disables the entry route zones (EX/EN, EX (OP)/EN,
followers and Final Exit) from participating in the alarm confirmation
process when the entry time starts.
Note
Sequential confirmation can still be established from two confirmed
zones, located off the entry route.
NO: The entry route zones will participate in the alarm confirmation
process when the entry time starts.