RISCO Group LightSYS 2 User Manual
Page 58
Advertising
Installing Bus Devices
Page 58
Completing the Installation
To complete the installation
1. Mount the back panel to the wall using affixing screws
2. Connect the system to the mains power
Note:
If no back tamper is connected set SW1‐4 to ON position to avoid tamper alarm
3. Close the front cover and close the locking screw
4. Upon completion of LightSYS2 bus device installation, module wiring, and
DIP switch and jumper setting, proceed to Chapter 4 Installer Programming
and Chapter 5 Using the Installer Non‐Programming Menus
Advertising