RISCO Group LightSYS 2 - Manual (Page 136)

Installer Programming
Page 136
Utility Output: Pattern of Operation
Quick Keys Parameter Default Range

Pulse N/C 05 seconds 01‐90 seconds
The utility output is always activated (N/C) before it is triggered
(pulled down to negative).
When triggered, it deactivates for the pulse duration specified below
and then reactivates automatically.
1. Press

and then press .
2. Choose the desired pulse duration, between 01‐90 seconds.
3. Press and set the activation by choosing ALL or ANY using
the key.
4. Press and define a label for the UO (refer to the note below).

Latch N/C
The utility output is always Activated (N/C) before it is triggered
(pulled down to negative). When triggered, it deactivates and remains
deactivated (latched) until the operation is restored.
1. Press and then press .
2. Using the key select ALL or ANY to set the activation and
press .
3. Using the key select ALL or ANY to set the deactivation
and press .
4. Define the output label and press

Pulse N/O 05 seconds 01‐90 seconds
The utility output is always deactivated (N/O) before it is triggered
(pulled up). When triggered, it activates (is pulled down) for the
pulse duration specified below, then deactivates automatically.
1. Press and then press .
2. Choose the desired pulse duration, between 01‐90 seconds
3. Press and set the activation by choosing ALL or ANY using
the key
4. Select a label for the UO (refer to the note below).