RISCO Group LightSYS 2 - Manual (Page 189)

Installer Programming
Page 189
Quick Keys Parameter Default Range
2. Use the or keys to position the cursor over the ID
filed and enter the Bus Zone ID number that you are assigning
or deleting. Make sure that the detectorʹs physical ID number
is identical to the ID number you select during programming.
3. Using the arrow keys move to the Type field. Use the
key to toggle and select the detectorʹs type:
 OPR12: WatchOUT PIR
 ODT15: WatchOUT DT
 WatIN: WatchIN
 ILun3: Industrial Lunar Grade 3
 iDTG3: iWISE DT Grade 3
 iQUG3: iWISE QUAD Grade 3
 iDTG2: iWISE DT Grade 3
 iQUG2: iWISE QUAD Grade 2
 BZ1: Single BUS zone expander
4. Press to confirm. Repeat the process for the other bus
detectors
Note:
The iWISE BUS detectors have additional input on board. When
selecting iWISE Bus detector the following question will appear: ʺLink
Bus Detector to zone xx? ʺ Selecting Yes will assign the input as the
consecutive zone of the selected iWISE Bus detector.
For example: If Bus detector with ID 0:01 (Zone 1 in the system) is
defined as iQUG3 then the input of the zone will be assigned as Zone 2.
 
GSM
 To specify and configure an installed GSM/GPRS module
1. Through the menu selection, the following display appears:
GSM MODULE
TYPE=NONE
2. With the cursor positioned at the TYPE field, use the key
to toggle and choose the GSM option.
3. Press to store your choice