RISCO Group LightSYS 2 User Manual
Page 183
Installer Programming
Page 183
Quick Keys
Parameter
Default
Range
Utility Output
To choose/modify a utility output
1. Through the menu selection, the following display appears:
UTIL OUTPUT:
ID=01 TYPE=
2. Use the
or
keys to position the cursor over the
UOʹs ID number for which you want to assign (or delete) a
utility output. The first UO must be assigned to the first ID
number, which is 01.
Note:
Make sure that the UO’s physical ID number has been ʺdip
switchʺ programmed as described in Setting Bus Accessory ID
Numbers, page 40.
3. Place the cursor on the TYPE field and use the
key to
toggle between the options provided to select the UO type, as
follows:
NONE
UO04 (a 4‐Output Relay‐Type Unit)
UO08 (an 8‐Output Solid‐State Type Unit)
XO08 (the X‐10 Transmitting Module)
UO02 (2‐Output Relay Type located on the 4A switched
power supply expansion module or wireless expander)
4. Press
to confirm (and store) your choice.
5. Repeat the process for any other Utility Output modules in the
system (up to the systemʹs maximum of four, depending on
your installed model).
6. Press
to return to the previous programming level.
If a Utility Output module is found and NONE has been
selected, the following display appears:
**DELETE**
ARE YOU SURE? N
Press
to return to the prior display.
‐OR‐
7. Press
to select Y YES and press
to confirm the
delete.