RISCO Group LightSYS 2 - Manual (Page 59)

Installer Programming
Page 59
Chapter 4 Installer Programming
Programming Methods
Program the LightSYS2 through one of three methods:
Configuration Software (Local or remote)
Program Transfer Module (PTM)
LCD Keypad
Configuration Software
A software application that enables you to program the LightSYS2 from a PC computer. It
offers the following alternatives:
Working locally, through a portable computer connected to the LightSYS2 via
cable
Working at a remote site, communicating with the LightSYS2 via one of the
following options:
o A phone line and modem
o TCP/IP network using the IP Module
o GPRS using the GSM/GPRS communication module
For further information on programming the LightSYS2 via the Configuration Software, refer
to the Configuration Software manual.
PTM: Data Storing Device
The PTM is a tiny circuit board into which the LightSYS2 panel can transmit a copy of the
systemʹs configuration. The PTM stores this copy and can also transmit the configuration
information back to the LightSYS2 panel.
 To copy from a programmed main panel into the PTM:
1. Position the PTM on PLUG 1 connector on the main panel with the red LED facing
the row of terminals on the main panel. The red LED flashes slowly.
2. Position the default DIP switch 2 to the ON position.
Note:
The DIP2 should be software enabled (Installer programming Quick key 1 5 1)
3. From an LCD keypad, access the main Installer Programming menu.
4. Without making any changes, exit the main Installer Programming menu by
pressing [0]. The LED on the Program Transfer module flashes rapidly, and the
keypad displays the following:
Saving data in
PTM Accessory