RISCO Group LightSYS 2 - Manual (Page 115)

Installer Programming
Page 115
Quick Keys Parameter Default Range
ZZ
MW (Microwave) Range Trimmer
Defines the microwave channel range.
MINIMUM 25% 50% 65%  85%  MAXIMUM  TRIMMER
(MW is defined by the trimmer setting on the PCB)
ZZ
Alarm Logic PIR and Microwave
Determine the detector’s logic of defining an alarm.
 PIR & MW (and Microwave) – An alarm is activated when both PIR
and MW channels detect an alarm (AND Logic).
 PIR / MW (or Microwave) ‐ An alarm is activated when either PIR or
MW channels detect an alarm (OR Logic).
ZZ
Lens Type Wide Angle
Defines the actual lens of the detector.
WIDE ANGLE BARRIER / LONG RANGE
ZZ
Anti‐Mask Enable
Defines the operation of Anti Masking detection.
DISABLE ENABLE
ZZ
Arm/Disarm No
Defines the operation of the LEDs and Anti masking detections while
the detector is armed.
 Active IR AM and Proximity AM (Anti masking) is enabled.
LEDs behave according to the LEDs parameter definition.
YES – Active IR AM and Proximity AM (Anti masking) is disabled
LEDs are disabled.
ZZ
Green Line Yes
This feature defines the activation of the microwave channel while the
system is disarmed.
NO ‐ Green Line feature is disabled. MW is constantly activated.
YES ‐ Green Line feature is enabled. This option conforms to
environmentally friendly standards by avoiding surplus emission.
ZZ
Sway No
This option allows the recognition and immunity of swaying objects in
a known pattern.
NO ‐ Sway is disabled.
YES ‐ Sway is enabled.