RISCO Group LightSYS 2 - Manual (Page 114)

Installer Programming
Page 114
Quick Keys Parameter Default Range
ZZ
Anti Mask Sensitivity
Defines the sensitivity of the active IR AM: LOW HIGH
ZZ
Lens Type Wide Angle
Defines the actual lens of the detector.
WIDE ANGLE BARRIER / LONG RANGE
ZZ
Anti‐Mask Enable
Defines the operation of Anti Masking detection.
DISABLE Enable
ZZ
Arm/Disarm No
Defines the operation of the LEDs and Anti masking detections while the
detector is armed.
 Active IR AM and Proximity AM (Anti masking) is enabled.
LEDs behave according to the LEDs parameter definition.
YES – Active IR AM and Proximity AM (Anti masking) is disabled
LEDs are disabled.
ZZ
Prox Anti‐mask Enable
Defines the operation of proximity anti masking detection.
 DISABLE Enable
Bus Zone: WatchIN DT Grade 3
Quick Keys Parameter Default Range
ZZ
LEDS 3 LEDS
Defines the LEDS operation mode.
OFF ‐ Disables the LEDS operation.

RED ONLY ‐ Only the Red LED will operate. This option is highly
recommended to avoid the possibility that a burglar will “Learn” the
detector behavior.
3 LEDS - All 3 LEDs will operate..
ZZ
Detection Sensitivity Normal
Defines the sensitivity of the detector (MW + PIR).
LOW MEDIUM NORMAL 
ACT (Anti‐Cloak™ Technology)