RISCO Group LightSYS 2 - Manual (Page 184)

Installer Programming
Page 184
Quick Keys Parameter Default Range
 
Power Supply
 To choose/modify a power supply
1. Through the menu selection, the following display appears:
POWER SUPPLY:
ID=01 TYPE=
2. Use the or keys to position the cursor over the
power supply ID number for which you want to assign (or
delete) a power supply. The first PS must be assigned to the
first ID number, which is 01.
Note:
Make sure that the power supply’s physical ID number has
been ʺdip switchʺ programmed as described in in Setting Bus
Accessory ID Numbers, page 40.
3. Place the cursor on the TYPE field and use the key to
toggle between the options provided to select the power
supply type, as follows:

NONE

PS02: 3A power supply
4. Press . The following display appears:
P=1234 PS=1
YYYY
5. Use the or keys and the key to assign the
partitions.
6. Press The following display appears:
Controls: PS=1
1)BELL/L.SPEAKN
If a bell siren or loudspeaker is connected to the Power Supply
module, press to select Y YES; otherwise, press .
Note:
If YES is selected, the system will look for, detect, and sound
any problems in the sounder circuit.
7. Repeat the process for any other power supply modules in the
system, up to the systemʹs maximum of four, depending on
your installed model