Altera Stratix GX Transceiver User Manual
Page 304
B–8
Altera Corporation
Stratix GX Transceiver User Guide
January 2005
Output Ports
rx_errdetect[]
No
Indicates whether the
8B/10B decoder
detects an error code.
Output port [NUMBER_OF_CHANNELS *
DWIDTH_FACTOR - 1..0] wide. If you set
the
USE_8B_10B_MODE
parameter to
OFF
, the
rx_errdetect
port is not
available.
rx_disperr[]
No
Indicates whether the
8B/10B decoder
detects a disparity
error.
Output port [NUMBER_OF_CHANNELS *
DWIDTH_FACTOR - 1..0] wide.
rx_signaldetect[]
No
Indicates whether there
is a legal voltage level
on the input buffer.
Output port [NUMBER_OF_CHANNELS -
1..0] wide. This port is available only if the
PROTOCOL
parameter is set to
XAUI
or
GigE
. This signal is always set in the
modes in which it is enabled. It is still
enabled even after the signal is a forced
HIGH for backward compatibility with
existing designs.
rx_bisterr[]
No
Error status signal for
the self test.
Output port [NUMBER_OF_CHANNELS -
1..0] wide. This port is available only if the
USE_SELF_TEST_MODE
parameter is
turned on.
rx_bistdone[]
No
Indicates whether the
self test is complete.
Output port [NUMBER_OF_CHANNELS -
1..0] wide. This port is available only if the
USE_SELF_TEST_MODE
parameter is
turned on.
rx_a1a2sizeout[]
No
Reports the
a1a2size
signal as
seen by the word
aligner.
Output port [NUMBER_OF_CHANNELS *
DWIDTH_FACTOR - 1..0] wide.
tx_out[]
Yes
Serialized transceiver
block transmitter
channel data signal.
Output port [NUMBER_OF_CHANNELS -
1..0] wide.
Table B–2. Output Ports (Part 4 of 4)
Port Name
Required
Description
Comments