Parameter descriptions – Altera Stratix GX Transceiver User Manual
Page 305
Altera Corporation
B–9
January 2005
Stratix GX Transceiver User Guide
Parameter
Descriptions
describes the Stratix GX device parameters.
Table B–3. Parameter Descriptions (Part 1 of 6)
Parameter
Type
Required
Comments
OPERATION_MODE
String
Yes
Specifies the operation of the transceiver block
transmitter PLL and transceiver block receiver PLL.
Values are
RX
,
TX
, and
DUPLEX
. If the
PROTOCOL
parameter is set to
XAUI
, then you must set the
OPERATION_MODE
parameter to
DUPLEX
.
LOOPBACK_MODE
String
No
Specifies the operation of the loopback. Values are
NONE
,
SLB
, and
PLB
. If omitted, the default is
NONE
.
Values other than
NONE
are available only when the
OPERATION_MODE
parameter is set to
DUPLEX
.
REVERSE_LOOPBACK
_MODE
String
No
Specifies the operation of the reverse loopback.
Values are
NONE
, and
RSLB
. If omitted, the default is
NONE
. Values other than
NONE
are available only
when the
OPERATION_MODE
parameter is set to
DUPLEX
.
PROTOCOL
String
Yes
Specifies the protocol. Values are
XAUI
,
SONET
,
GigE
, and
Basic
.
NUMBER_OF_CHANNELS
Integer
Yes
Specifies the number of transceiver block receiver or
transmitter channels. Values are
1
through
20
.
NUMBER_OF_QUADS
Integer
Yes
Specifies the number of transceiver blocks.
CHANNEL_WIDTH
Integer
Yes
Specifies the width of the dataout signal from the
transceiver block receiver or transmitter channel atom.
Use the following settings:
For more information, see the table in the comments
for the
DATA_RATE
parameter.
Setting of
PROTOCOL
Parameter
XAUI
SONET
GigE
Basic
Channel Width
Values
16
8
and
16
8
8
,
10
,
16
, and
20