Figure 3–25 – Altera Stratix GX Transceiver User Manual
Page 76
3–30
Altera Corporation
Stratix GX Transceiver User Guide
January 2005
Basic Mode MegaWizard Plug-In
Figure 3–25. MegaWizard Plug-In Manager - ALTGXB (Page 3 of 9) - General (1)
Notes to
:
(1)
Basic protocol mode supports duplex, receive- only, or transmitter-only operation modes.
(2)
This value can be from 1 to the maximum number of channels available on the device.
(3)
The correct channel width setting depends on whether you are using 8B/10B decoding. With 8B/10B, 8 bits is single
width, 16 bits is double width. Without 8B/10B, 8 bits is single width, 16 bits is double width, 10 bits is single width,
and 20 bits is double width.
(4)
Refer to the Stratix GX Analog Description chapter for more information.
(5)
The rxdigitalreset port resets the digital blocks in the receiver channel. Each active receiver channel has its own
digital reset. The txdigitalreset port resets the digital blocks of the transmitter channel. Each active transmitter
channel has its own digital reset. The rxanalogreset port resets the receiver’s analog circuits including the
receiver PLL. Each active receiver channel has its own analog reset. The pll_areset port resets the entire
transceiver block (all receiver and transmitter digital and analog circuits including receiver and transmitter PLLs).
The pllenable port enables the entire transceiver block; if deasserted, the entire transceiver block is held in the
reset condition.
(6)
The pll_locked active high signal that indicates that the transmitter PLL is locked to the reference input clock.