Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 100)

Global Configuration Commands
Display configuration &V
©Restricted Page: 94 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
6.15 Display configuration &V
6.15.1 Description.
This command is used to display the Wireless CPU ® configuration.
6.15.2 Syntax
Action command
AT&V[<n>]
Q:<val1> V:<val2> S0:<val3> S2:<val4> S3:<val5> S4:<val6> S5:<val7>
+CR:<val8> +CRC:<val9> +CMEE:<val10> +CBST:<val11>
+SPEAKER:<val12> +ECHO:<val13> &C:<val14> &D:<val15> %C:<val16>
[+IPR:<val17>] +ICF:<val18> +IFC:<val19>
OK
Note: For each <valx> parameter, please refer to the corresponding command.
Read command
None
Test command
None
6.15.3 Parameters and Defined Values
<n>: display control parameter
0 display the Wireless CPU ® configuration in RAM (default value if
no parameter provided)
1 display the Wireless CPU ® configuration in EEPROM
2 display the Wireless CPU ® factory configuration
6.15.4 Parameter Storage
None.