Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 50)

Open AT ® Commands
Wavecom Open AT ® Control Command +WOPEN
©Restricted Page: 44 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
Command Responses
AT+WOPEN=7 +WOPEN: 7,12
OK
Note: Open AT ® application started on the target.
AT+WOPEN=8 +WOPEN: 8,1,19,24
OK
Note: Safe Boot is active and uses the keys 19 and 24
AT+WOPEN=8,1,10,12 OK
Note: Safe Boot is active and uses the keys 10 and 12.
AT+WOPEN=8,1,10,10 +CME ERROR: 3
Note: Two different keys have to be supplied
AT+WOPEN=8,1,10,16 +CME ERROR: 3
Note: The two supplied keys have to be on the same row or
on the same column
AT+WOPEN=3 +CME ERROR: 532
Note: the embedded application is activated so the flash
objects are not erased
.
AT+WOPEN=4 +CME ERROR: 532
Note: the embedded application is activated so it cannot be
erased
AT+WOPEN=0
Note: Stop the embedded application.
OK
+WIND: 3
Note: Product reset in order to stop the embedded
application.
AT+WOPEN=3 OK
Note: The flash objects are erased
AT+WOPEN=4 OK
Note: The embedded application is erased
AT+WOPEN=6 +WOPEN: 6,768,832
OK
Note: 768 Kbytes are reserved for the A&D storage place,
and 832 for the Open AT ® application
AT+WOPEN=6,1280 +CME ERROR: 550
Note: The current Open AT ® application size is too big to
allow this new A&D storage place size.