Gprs commands – Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) User Manual
Page 283
GPRS Commands
GPRS parameters customization: +WGPRS
©Restricted
Page:
93 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001
VOLUME 2
August 23, 2007
14.2.6
Notes
Additional information for <class>:
Multislot class Maximum number of slots Minimum number of slots Type of MS
Rx
Tx
Sum
T
ta
T
tb
T
ra
T
rb
2
2
1
3
3
2
3
1
1
8
4
1
5
3
1
2
1
1
10
4
2
5
3
1
2
1
1
12 4
4
5
2
1
2
1
1
Type 1 MS is not required to transmit and receive at the same time.
When the Wireless CPU
®
is set in the "CG" class, the ME always automatically
performs a GPRS attachment after init, so AT+WGPRS? always gives +WGPRS: 0,0
for the parameter 0.
Additional information for <mode>= 9:
• When the user enables the GPRS/EGPRS network capability indication, the
Wireless CPU
®
returns OK response, and it sends immediately an unsolicited
response.
• The unsolicited responses are sent to all ports.
• When the GPRS/EGPRS network capability indication is enabled (with +
WGPRS AT command), each time GPRS or EGPRS technologies availability are
detected on the used network, an unsolicited response +WGPRSIND will be
returned by the Wireless CPU
®
.