Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) User Manual
Page 633
I/O Commands
Wavecom Interrupt Pin Configuration +WIPC
©Restricted
Page:
85 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001
VOLUME 4
August 23, 2007
22.4.3
Parameters and Defined Values
<InterruptId>:
interrupt pin identification
0
interrupt INT0
1 interrupt
INT1
<mode>:
requested configuration
0
the PIN is configured as GPIO
1
the PIN is configured as Interruption (default)
<EdgeState>:
interruption raising mode
0
interruption happens with high to low edge (default)
1
interruption happens with low to high edge
2
interruption happens with both edge (high to low and low to
high edge): de-bounce processing is applied
<ProcessingMode>:
0 de-bounce
(default)
1 by
pass
2 stretching
<DebounceTiming>: de-bounce duration in units of 7.8 ms
1-7
default value: 1
22.4.4
Parameter Storage
The <mode>, <EdgeState>, <processingMode> and <DebounceTiming> parameters
are stored in EEPROM without using the AT&W command.