Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 277)

GPRS Commands
GPRS parameters customization: +WGPRS
©Restricted
Page: 87 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
14.2 GPRS parameters customization: +WGPRS
14.2.1 Description
This Wavecom proprietary command modifies some Wavecom GPRS parameters:
• the ATTACH-STATUS (the ME does or not perform automatically a GPRS
attachment after initialization),
• the PDP-INIT-STATUS (activates automatically or not some defined PDP
contexts after initialization),
• the user-defined multislot class. This parameter represents either the GPRS or
EGPRS class selected by the user to perform power saving (by reducing TX
/uplink time slots).
In addition, this command allows to:
• set automatically "ACTIVABLE" some defined PDP contexts after initialization,
• set some parameters for PALM
® OS software: PPP Silent Mode.
PPP waits for PPP Client to start the dialog and Slow CONNECT (due to the delay in
the processing of PALM ® OS, the CONNECT is sent one second after the dialing
command request).
The Wavecom Wireless CPU ® must be rebooted to activate the new setup except for
<mode> 3, 5, 6 and 7 (please refer to "Defined Values" section
1
14.2.3).
When the GPRS/EGPRS network capability indication is enabled (with + WGPRS AT
command), each time GPRS or EGPRS technologies availability are detected on the
used network, an unsolicited response +WGPRSIND will be returned by the Wireless
CPU ® .
14.2.2 Syntax
• For <mode>=9, <parameter>=2:
Action command
AT+WGPRS=<mode>,<parameter>
+WGPRSIND:<techno>
OK