Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 613)

Audio Commands
Wavecom Change Default Melody +WCDM
©Restricted
Page: 65 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
21.20.3 Parameters and Defined Values
<melody>:
melody number
0 no melody (default value)
1-10 melody 1 to 10
<player>: output used to play the melody
0 The melody will be played on the buzzer for any new incoming
voice call. (default value)
1 The melody will be played on the speaker for any new incoming
voice call.
21.20.4 Parameter Storage
The parameters are stored in EEPROM without using AT&W.command The default
values can be restored using AT&F.
21.20.5 Examples
Command Responses
AT+WCDM=? +WCDM: (0-10),(0-1)
OK
AT+WCDM=5
Note: Select melody #5
OK
AT+WCDM?
Note: Indicate the current melody
+WCDM: 5,0
OK
Note: Melody #5 is currently selected, and the buzzer is
selected to play it. An incoming call occurs, and the melody
#5 is played on the buzzer.
AT+WCDM=,1
Note: Select the speaker to play the melody on
OK
AT+WCDM? +WCDM: 5,1
OK
Note: The speaker is selected to play the melody if an
incoming call occurs.