Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 77)

Global Configuration Commands
Wireless CPU ® Behaviour Configuration +WBHV
©Restricted Page: 71 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
6.5.6 Notes
If <parameter1>=0, the command is used to configure when the Wireless CPU ® sent
the response of an outgoing voice call.
If <parameter1>=1, the command is used to configure the Wireless CPU ® power
consumption mode.
If <parameter1>=2, the command is used to configure when the Wireless CPU ® sent
the response for a call.
If <parameter1>=3, the command is used to activate/deactivate ENS feature.
If <parameter1>=3, new setting will be taken into account only after a Wireless CPU ®
reset. To be able to activate ENS feature, a STK session must be open (AT+STSF=1),
otherwise +CME ERROR: 3 occurs
The mix tone with voice feature (<parameter1>=4) allows not cutting the voice when
the Wireless CPU ® plays a tone during a voice communication.
The network registration denied indication feature (<parameter1>=5) is used to
change the +CREG indication response to return the cause of the network registration
reject.
The DTMF blank duration (<parameter1>=6) is used to configure the threshold in ms
used to separate 2 DTMF while using the DTMF decoding feature.