Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) User Manual
Page 270
Data Commands
V42 Bis Data Compression +DS
©Restricted
Page:
80 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001
VOLUME 2
August 23, 2007
13.8.3
Parameters and Defined Values
<dir>:
desired direction(s) of operation for the data compression feature,
from the DTE point of view
0
negotiated
1
transmit
only
2
receive
only
3
both directions, accept any direction (default value)
<neg>:
specifies whether the DCE may continue to operate or not if the
desired result is not obtained
0
do not disconnect if V42bis is not negotiated by the remote DCE
as specified in <dir> (default value)
1
disconnect if V42bis is not negotiated by the remote DCE as
specified in <dir>
<P1>:
maximum number of dictionary entries that may be negotiated
range: 512-2048 (default value: 2048)
<P2>:
maximum string length to be negotiated
range: 6-250 (default value: 20)
13.8.4
Parameter Storage
All parameters are stored in EEPROM using the AT&W command. The default value
can be restored using AT&F.
13.8.5
Examples
Command
Responses
AT+DS=?
+DS: (0-3),(0,1),(512-2048),(6-250)
OK
AT+DS=3,0,2048,250
OK
Note: Set new parameters
AT+DS?
+DS: 3,0,2048,250
OK