Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 72)

Global Configuration Commands
Wireless CPU ® Behaviour Configuration +WBHV
©Restricted Page: 66 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
6.5.3 Parameters and Defined Values
<parameter1>: configuration mode
0 configure Wireless CPU ® response on outgoing
voice calls (default value)
1 configure Wireless CPU ® working mode
2 configure the response delay for a call
3 active/deactive ENS feature
4 configure mix tone with voice feature
5 configure network registration denied
indication
6 configure DTMF blank duration for DTMF
decoder
<parameter2> configuration value
<parameter1> <parameter2>
0 0 Wireless CPU ® response is sent on call
establishment (default value)
0 1 Wireless CPU ® response is sent when audio
path is opened
0 / Interrogate Wireless CPU ® respond mode
1 0 fast idle mode is normal (default value)
1 1 fast standby mode
1 2 slow standby mode
1 / interrogate Wireless CPU ® init mode
2 0 response when the remote part hangs up
(default value)
2 1 OK will be displayed immediately after the ATD
command and +WIND: 5,x indication.
2 / interrogate Wireless CPU ® call respond mode
3 0 deactivate ENS feature (default value)
3 1 activate ENS feature
3 / interrogate ENS feature mode
4 0 deactivate the mix tone with voice feature
(default value)
4 1 activate mix tone with voice feature
4 / Get mix tone with voice feature mode state