Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 639)

Battery Commands
Wavecom Battery Charge Management +WBCM
©Restricted
Page: 91 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
23.2 Wavecom Battery Charge Management +WBCM
23.2.1 Description
This Wavecom proprietary command is used to manage the battery charging
operations (start and stop the charge, enable or disable unsolicited +WBCI battery
charge Indications) and to set the battery charge parameters.
Note:
Unsolicited responses for battery charge are only returned through one port (except
+WBCI: 0 and +WBCI: 1). If these responses are already activated on a port and if the
activation/deactivation is made on another port, the command will return "+CME
ERROR: 552" specific error.
23.2.2 Syntax
• For <Mode>=0 or 1:
Action command
AT+WBCM=<Mode>[,<ChargeInd>]
OK
• For <Mode>=2:
Action command
AT+WBCM=<Mode>
+WBCI: <Status1>,<BattLevel>
OK
• For <Mode>=3, <ChargeMode>=0:
Action command
AT+WBCM=<Mode>[,[<ChargeInd>][,[<BattLevelMax>],
[<BattLevelMin>],[<TPulseInCharge>], [<WBCITimer>],[<BattIntRes>,
[<BattChangeLevel>]]]]
OK